cclin
Newbie level 2
whenever I do simulation in HFSS10.1.3, the mesh error always exists (Please see the attached figure)
I design a L x H (14cm x 7 cm) antenna in 10 MHz. The sweep frequency is from 5-15 Mhz which means the radiation box should be at least 1514 cm. The "validate check" is ok; howver, as I run the simulation, it pops out mesh error.
why? Who can help me? thanks!
I design a L x H (14cm x 7 cm) antenna in 10 MHz. The sweep frequency is from 5-15 Mhz which means the radiation box should be at least 1514 cm. The "validate check" is ok; howver, as I run the simulation, it pops out mesh error.
why? Who can help me? thanks!