I ve encoutered one problem while programming xilinx FPGA kit. It shows cable is not connected. when i do autodetect cable it shows cable is connected but when i say program then again it says that cable isnot connected.
I'm guessing you are using Xilinx ISE iMPACT software and the Xilinx Parallel Cable IV. Correct?
iMPACT displays a lot of confusing messages as it searches the parallel port, USB port, and the JTAG chain. If you show us all the messages, maybe someone can see what's going wrong.
Please use a more descriptive message subject than "help needed".
I get this message quite often, but my problem is mainly due to the JTAG flylead not connected properly.
vivek_raj_verma said:
hi there,
I ve encoutered one problem while programming xilinx FPGA kit. It shows cable is not connected. when i do autodetect cable it shows cable is connected but when i say program then again it says that cable isnot connected.