rafei
Junior Member level 2
atmega128
I`m going to use atmega 128 to connect to a mmc,
i have some problems:
1)voltag droping when placing mmc in the board,
2)after some duration of programing my micro program never works properly.
Note: I program 128 with TNM programer by the RXT and RXD way.
Any sugestion?
Added after 57 seconds:
sorry: Rxd and Txd
I`m going to use atmega 128 to connect to a mmc,
i have some problems:
1)voltag droping when placing mmc in the board,
2)after some duration of programing my micro program never works properly.
Note: I program 128 with TNM programer by the RXT and RXD way.
Any sugestion?
Added after 57 seconds:
sorry: Rxd and Txd