Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Problem in programing atmega128

Status
Not open for further replies.
R

rafei

Junior Member level 2
Joined
Jul 1, 2009
Messages
22
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Location
Tehran
Activity points
1,386
atmega128

I`m going to use atmega 128 to connect to a mmc,

i have some problems:

1)voltag droping when placing mmc in the board,

2)after some duration of programing my micro program never works properly.

Note: I program 128 with TNM programer by the RXT and RXD way.

Any sugestion?

Added after 57 seconds:

sorry: Rxd and Txd
 

brother rafei ... sorry as i cant answer your question... but can you tell me where to get the tnm programmer?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top