Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Problem in getting data in device terminal using WIZI110 SR

Status
Not open for further replies.

varun_agr

Newbie level 5
Joined
Jan 6, 2012
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,390
Dear sir
I want to send serial data from FPGA kit to my LAPTOP ethernet. So I connected your wizi110sr in between FPGA and Laptop. But not getting proper data on your device terminal i.e. in ASCII(as shown in hyper terminal captured image)
I am attaching captured image of configuration tool, device terminal (when FPGA kit connected to my laptop with usb and when not connected to my laptop) and hyperterminal data. .( our baud rate of serial is 38400). MY LAPTOP IP IS 192.168.11.3.Kindly send us solution as early as possible.
With Regards,
Varun Maheshwari
Research Scholar
DEI,Dayalbagh
Agra
 

Attachments

  • wiznet1.doc
    4.4 MB · Views: 0

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top