Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

problem in Annotation in Capture CIS ??

Status
Not open for further replies.

kabaleevisu

Advanced Member level 2
Joined
Apr 14, 2010
Messages
615
Helped
85
Reputation
170
Reaction score
81
Trophy points
1,308
Location
Chennai,India
Activity points
4,507
Hi everyone
i am using cadence allegro 16.2 in my schematic design reset circuit which part reference is U3.i copied this circuit from page 3 and paste in page 4 .part reference is generate automatically changed from U3 to U10.
 

spudboy488

Full Member level 5
Joined
Oct 10, 2012
Messages
271
Helped
69
Reputation
140
Reaction score
72
Trophy points
1,308
Activity points
2,946
Since you copied the part, Allegro gave it the next available reference number. If you insist on keeping it U3, just change it by clicking on the reference designator and changing it. Then you will have a U3 on page 3 and a U3 on page 4 (which will cause other problem later).
 

sivamani

Full Member level 5
Joined
Jan 30, 2007
Messages
318
Helped
46
Reputation
92
Reaction score
42
Trophy points
1,318
Location
Hyderabad
Activity points
2,694
If u want to keep only one ckt then cut the section from page 3 and paste it in page 4. or chnage the refdes manually..
 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top