EricGuo
Newbie level 5
Hi,all
I use xilinx ISE and modelsim to design a project . Although the final output is like what i wanted , I get a error indication in modelsim consol after postmap simulation as following :
Error: d:/Xilinx/verilog/src/simprims/X_LATCHE.v(64): $width( posedge CLK:9939316 ps, :9939656 ps, 1400 ps );
can anyone explain this error message to me ? thank you in advance !
pls. can I write a constrain condition for LATCH in the xilinx ISE? IF can, How to ? :?: [/img]
I use xilinx ISE and modelsim to design a project . Although the final output is like what i wanted , I get a error indication in modelsim consol after postmap simulation as following :
Error: d:/Xilinx/verilog/src/simprims/X_LATCHE.v(64): $width( posedge CLK:9939316 ps, :9939656 ps, 1400 ps );
can anyone explain this error message to me ? thank you in advance !
pls. can I write a constrain condition for LATCH in the xilinx ISE? IF can, How to ? :?: [/img]