Hi,
I would like to know more about powerLine communication systems. if somebody have experianced on this field, mostly welcomes yours comments, ckts designs etc...
Hi did an evaluation on a Siemens ETHERNET POWER MODEM .Most of these products are based on the Intellon chip .
The architecture of this chip is very interesting .. The comunication is carried out in around 80 channels . The chip when is connected to power network tries to mesure the TRANSFER COURBE in the whole 80 channels
and it selects the best ones ..It only tries to comunicate through the best channels (the ones that offer best propagation of the signal)
This type of architecture should make it very reliable ..
But i found if your network is the same power circuit .. it works well!
8 ~10 Mbits .. But if the units are in a different circuit ..(different breaker
protection) The whole things stinks ..
I also tried to go to my neighbord's house and connect from there ..
no HOPE !..
So still is a gadget ! . not a reiliable all terrain device ..
I think that wireless is better ..!
anyways check the intellon web site !
and the **broken link removed**
several years ago I designed a prototype of a powerline modem. It uses direct sequence spread-spectrum and was able to communicate with 115kBit/s. It is possible to feed one phase and to get the receiving signal out of another phase. The distance you can reach depends on output-power (and law...). With 100mW an inhouse communication is possible, with about 1W you can also leave your house.
Have a look at ST7536,ST7537,ST7538 on ST website, you will also find app notes with schematics/source code.
HTH w*w.hth.com/plm-24/ have info about the snap protocol, commonly used in these analogue modems.
I think ST are the only company left doing analogue modems, most are now looking at dsp based systems for higher data rates.
I know ST are working on a new dsp based modem.
As far as i know ST chips are only "analog front ends". No signal processing , no clever modulation schemes. If you add some data
correction speed lowers below 2400 baud.
Intellon , Itran and Domosys also works in PLC business.
Hi,
I would like to know more about powerLine communication systems. if somebody have experianced on this field, mostly welcomes yours comments, ckts designs etc...