Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Hi, I just took a look at it. But it doesn't state other then a printing of "B10k". Other than that, there isn't any other printing on the potentiometer.
I'd be surprised if this potentiometer were rated for more than 0.25W, unless it's diameter is something like 20mm or more ..
Read the section on pots power to make sure that you don't exceed the allowable current even while using any small section of it .. **broken link removed**
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
