DoYouLinux
Advanced Member level 4
Hi all,
Just would like to know that, has anyone been able to do a Post-Layout simulation in Cadence using a UMC 0.18mm RF technology ?
I have know from many friends that UMC don't provide a technology file to do a post-layout simulation, but I am not sure about this.
Thank you so much,
DYLinux
Just would like to know that, has anyone been able to do a Post-Layout simulation in Cadence using a UMC 0.18mm RF technology ?
I have know from many friends that UMC don't provide a technology file to do a post-layout simulation, but I am not sure about this.
Thank you so much,
DYLinux