Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Post Layout/Calibre Pex

Status
Not open for further replies.

hannover90

Member level 4
Member level 4
Joined
Dec 8, 2009
Messages
70
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Location
Germany
Visit site
Activity points
1,784
Dear all,

I have a problem with post layout.

I have already created the file: "myCyrcuit.pex.netlist" due Calibre/pex. For output I chose "Gate Level", "R+C+CC":

========================================================================
CALIBRE xRC WARNING / ERROR Summary
------------------------------------------------------------------------
xRC Warnings = 0
xRC Errors = 0
========================================================================

Now, I don't know, how can I use the created file "....pex.netlist" for simulation. Which steps schould I take for simulation?

For any help, I would be thankful.

Best regards

Hannover90
 

Dear all,

I have already found out how can I simulate my circuit after post layout.

Thanks for your attention.

Best regards

Hannover90
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top