burningmosfet
Member level 1
Hello boys is there any way to count the number of pin in a schematic with Orcad 16.3 assuming you still haven't set the footprint for the parts?
Thankyou very much in advance :roll:
---------- Post added at 08:51 ---------- Previous post was at 08:31 ----------
My colleague solved it in 30 seconds; if anybody needs =>
Go under design resources
Click on NameOfYourSchematic.dsn
Go to the main menu, edit -> object proprieties -> click on Pins and go down to the bottom of the page, on the left there is the number of pins
Thankyou very much in advance :roll:
---------- Post added at 08:51 ---------- Previous post was at 08:31 ----------
My colleague solved it in 30 seconds; if anybody needs =>
Go under design resources
Click on NameOfYourSchematic.dsn
Go to the main menu, edit -> object proprieties -> click on Pins and go down to the bottom of the page, on the left there is the number of pins