Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
unsigned char uart_rd;
unsigned char data;
unsigned char temp[10];
unsigned char N = 0;
// LCD define
// Lcd pinout settings
sbit LCD_RS at RB4_bit;
sbit LCD_EN at RB5_bit;
sbit LCD_D7 at RB3_bit;
sbit LCD_D6 at RB2_bit;
sbit LCD_D5 at RB1_bit;
sbit LCD_D4 at RB0_bit;
// Pin direction
sbit LCD_RS_Direction at TRISB4_bit;
sbit LCD_EN_Direction at TRISB5_bit;
sbit LCD_D7_Direction at TRISB3_bit;
sbit LCD_D6_Direction at TRISB2_bit;
sbit LCD_D5_Direction at TRISB1_bit;
sbit LCD_D4_Direction at TRISB0_bit;
void main() {
ANSEL = 0; // Configure AN pins as digital I/O
ANSELH = 0;
C1ON_bit = 0; // Disable comparators
C2ON_bit = 0;
TRISB = 0;
PORTB = 0xFF;
UART1_Init(9600);
Delay_ms(100);
Lcd_Init();
Lcd_Cmd(_LCD_BLINK_CURSOR_ON);
Delay_ms(100);
do {
if (UART1_Data_Ready()){ //<------ Check if a character has been received before reading
uart_rd = UART1_Read(); // read the received data,
UART1_Write(uart_rd);
temp[N] = uart_rd;
N = N +1;
if (N == 9) // temp storing string
{
Lcd_Cmd(_LCD_CLEAR);
Lcd_out(1,1,temp);
}
}
} while(1);
}
Attach the PIC's MAX232 TX/RX to your RS-232/USB converter and simulate RFIDs by entering 10 digit numbers via MikroC terminal program.
BigDog
Are you saying PIC max232 TX/RX pins connect to RS-232/USB or RS232 TX/RS max232 connected to RS-232/USB ?
They are opposite sex. I haven't try plug in yet.
Linspire
---------- Post added at 19:48 ---------- Previous post was at 18:47 ----------
I didnt see any outputs from mikroC terminal key in.
I attached RS232-UBS's TX - RS232-In (MAX232) ; RS232-USB's RX- RS232-Out(MAX232).
That's correct connections, right ?
Linspire
When I sent character of 1, it sent back '?', LCD output display nothing.
---------- Post added at 20:31 ---------- Previous post was at 19:48 ----------
So far, I'm only managed to get terminal input = output correct, but LCD display incorrectly.
Any idea why ?
---------- Post added at 20:33 ---------- Previous post was at 20:31 ----------
So far, I'm only managed to get terminal input = output correct, but LCD display incorrectly.
Any idea why ?
I am doing the same project as urs, and tried ur coding you have posted. But I used PIC18f4525. Unfortunately it cant compile whereas when i tried for PIC16f8870 it can compile. Can sum1 tel me why it is not working, got so many errors..