thannara123
Advanced Member level 5
Hello experts , I have an old pickit2 programmer ,I am trying to burn a hex code to the Pic16f877a.
The whenever I load the hexa code by clicking write button ,the Pickit2 shows successfully burned ..
If I read it again it shows the hex ,.
But the problem is whenever I reconnect USB of the Pickit 2,
And reads the hex code which is empty.
Why the Pic16f877A is not burn properly .
Is it Pickit2 problem .
The whenever I load the hexa code by clicking write button ,the Pickit2 shows successfully burned ..
If I read it again it shows the hex ,.
But the problem is whenever I reconnect USB of the Pickit 2,
And reads the hex code which is empty.
Why the Pic16f877A is not burn properly .
Is it Pickit2 problem .