Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

PCB re-dimensioning - OrCAD

Status
Not open for further replies.
Y

yolco

Member level 2
Joined
Jun 12, 2009
Messages
48
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,286
Activity points
1,787
Hi,

is there any easy way to re-dimensioning a finished layout.

I need to increase the size of the board, length&width. It is finished, so this modificationes involves all board components.
I don't need to change components placement, neither routing. I only need to make bit bigger the board, and if it is possible to center all in the new dimensions.

Which are the steps to do it properly?

Regards.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top