Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pcb maknig for very small components

Status
Not open for further replies.
A

aliyesami

Full Member level 6
Full Member level 6
Joined
Jan 7, 2010
Messages
369
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,296
Location
USA
Visit site
Activity points
4,190
is it possible to make a pcb for molex FPC connector with .05mm pitch and .15 pad width at home ? I make normal pcbs home home but I printed this molex connector pin layout on printer and the pads are joined at many places . I have HP officejet pro 8600.

If i cant produce such small prints at home does anyone know any cheap pcb manufactures I can use?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top