Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

pc based oscilloscpe , circuit is connected by parallel por

Status
Not open for further replies.
A

akhilaneeth

Newbie level 1
Joined
Apr 13, 2010
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
kottayam
Activity points
1,287
i am doing project about pc based oscilloscope.here the circuit is connected with pc through a parallel port.and it is to be run in turbo c.But tthere is showing link error...i m not able to correct it.
 

pc based oscilloscpe

you need to give extremly more information to get any help at all
 

Re: pc based oscilloscpe - help needed

Have you developed your own software to get output on the PC or are you using a FPGA based solution? I know of a lot of implementations in which a signal is fed into a FPGA and it displays the output on a PC. The main issue with those is to get the display horizontal as against vertical.

Regards,
Saad Rahman
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top