Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

P16Pro40 and Picallw v.14a

Status
Not open for further replies.
C

C3pO

Newbie level 1
Joined
May 8, 2003
Messages
1
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
8
hey guys very much a newbie here

Got a question

I am trying to load a hex program on a pic12c509a chip with picallw, everytime I try to "program" it errors out on me, I have read the topic **broken link removed** about adjusting the Pro Delay to 2000 and unchecking the Auto Adjust, but I still get an error,

address=0006 buffer=3FFF device=offf

It must see the programmer as if I do a blank check, it comes back to as device is blank, I think it sees it...

Any help on this subject would be great

C3pO
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top