[SOLVED] OrCad 16.0 - Sliding PCB components/wires to the left?

Status
Not open for further replies.
M

mspagon

Junior Member level 3
Joined
Nov 17, 2012
Messages
26
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,490
I have to modify an existing PCB in OrCad 16.0. They need to shrink the PCB in the X-dimension by 1-2 inches. I need to grab the components, vias, attached nets on the right edge of the PCB and slide everything over to the left as much as I can. There is room for it, I just need to learn how!

I know about move, right click, temp group, then move... but I have the problem where the wires don't come along correctly, OR if i select the wire to move, it selects the WHOLE wire and doesn't stay connected on the other end...

THANKS
 
Last edited:

use temp group option and select what u want then try moving and also check whether anything is protected..
 

You can use Find and select the Cline segment and via. right click temp group. and move.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…