Spectre90
Newbie level 6
ok this might be confusing but bare with me....
im trying to make 12-bit stop counter where i have one button input that stop each 4-bits slots i'll put in my segment display module
whenever i press a button, it stops one segment to display a number and if i press the same button again, displays a number on the other display with the 1st still on, then same with the third display; the last display will be fixed values.
i made a block diagram to explain it better.
i need some idea to make this module
should i go with making 3 different module with an enable or state (or case) statement to implement
i hope the drawing helps
im trying to make 12-bit stop counter where i have one button input that stop each 4-bits slots i'll put in my segment display module
whenever i press a button, it stops one segment to display a number and if i press the same button again, displays a number on the other display with the 1st still on, then same with the third display; the last display will be fixed values.
i made a block diagram to explain it better.
i need some idea to make this module
should i go with making 3 different module with an enable or state (or case) statement to implement
i hope the drawing helps