the_paradox
Newbie level 4
Please refer https://in.element14.com/broadcom-limited/aba-31563-blkg/ic-amp-rf-si-31563-sot-363-6/dp/7820526
Assume that I am using this in my circuit. Now that being said, I want to design a bi-directional amplifier.
My idea is to put two of these chips, one for downlink and one for uplink. The design is for cellular communication bosster by the way.(900MHz band and 2100MHz band).
First let's focus on only 900MHz band. My requirement is to have only one input antenna(Communicating with BS) and one output antenna(Indoor). These are to be connected through Co-Ax(RG-6 50Ohm). In between two antennas, comes this booster circuit.
My questions are:
1) Do you think the above Chip can be used as I am planning to use(one for uplink and one for downlink?) Will at least the concept work?
2) Is there anything I am missing?(Don't worry about the legality etc as I will make sure they will be met).
You can assume that I have a good antenna set-up. Just give me inputs for only amplifier circuitary.
Thank You
Regards
Prasad Bhat
Assume that I am using this in my circuit. Now that being said, I want to design a bi-directional amplifier.
My idea is to put two of these chips, one for downlink and one for uplink. The design is for cellular communication bosster by the way.(900MHz band and 2100MHz band).
First let's focus on only 900MHz band. My requirement is to have only one input antenna(Communicating with BS) and one output antenna(Indoor). These are to be connected through Co-Ax(RG-6 50Ohm). In between two antennas, comes this booster circuit.
My questions are:
1) Do you think the above Chip can be used as I am planning to use(one for uplink and one for downlink?) Will at least the concept work?
2) Is there anything I am missing?(Don't worry about the legality etc as I will make sure they will be met).
You can assume that I have a good antenna set-up. Just give me inputs for only amplifier circuitary.
Thank You
Regards
Prasad Bhat