snipex
Junior Member level 3
Hi
I just got my prototype boards and I'm currently testing it, but there is a problem.
After I turn on the power supply the NCV3063 starts working. I can see the timing oscillator saw and the switching but only for approximately 1ms.
After that the oscillator stops (no more saw waveform) and the switch goes into short circuit.
Do you have any idea what causes this?
I just got my prototype boards and I'm currently testing it, but there is a problem.
After I turn on the power supply the NCV3063 starts working. I can see the timing oscillator saw and the switching but only for approximately 1ms.
After that the oscillator stops (no more saw waveform) and the switch goes into short circuit.
Do you have any idea what causes this?