Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronic Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Motion Detector Project- which microcontroller and diagram ?

Status
Not open for further replies.

flagmino

Newbie level 2
Joined
Sep 12, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Canada
Activity points
1,297
motion detector project

I am making this project where the signal from a motion detector has to trigger 6 sequentially timed signals (from a controller?). The signals will activate a cell phone touch button as if they were pressed by an operator. i have both the cell and motion detector covered. All I want to start with is an idea of what chip (and diagram setup) to use.

thanks

ray

I will post my progress and eventually the working system.
 

seadolphine2000

Advanced Member level 3
Joined
Apr 12, 2005
Messages
881
Helped
122
Reputation
244
Reaction score
86
Trophy points
1,308
Activity points
7,374
motion detection project

What "Chip" are you asking about?
Do you mean the microcontroller? If so, check this website:
http://www.frisnit.com/sms/

I assume you have a cell phone with a serial cable interface.
 

flagmino

Newbie level 2
Joined
Sep 12, 2009
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Location
Canada
Activity points
1,297
project on motion detector

yes... the microcontroller.

The cellphone is most of the time activated manually. pressing a touch pad allows the current to circulate and sends a signal to the phone microcontroller (see OpenCell picture). Instead of having a finger mechanically triggering the touch pad and sending the electric signal, I have the motion detector sending the signal. (see CellButtonSwitch picture). But I can only get one signal from the motion detector. I need the one signal from the motion detector to initiate a serie of 9 signals that will tell the phone what to do in order to call me as if I was doing it manually.

 

Status
Not open for further replies.
Toggle Sidebar

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top