ilter
Member level 4
Dear all,
I have a question. I use tmsc 0.18µm. I use miminum width of 0.22µm and length of 0.18µm. Can this one be draw in layout? Because it must use contact.
But contact's width and length are longer than my mos. It may be errors.
Thanks. If you know,please tell me.
I have a question. I use tmsc 0.18µm. I use miminum width of 0.22µm and length of 0.18µm. Can this one be draw in layout? Because it must use contact.
But contact's width and length are longer than my mos. It may be errors.
Thanks. If you know,please tell me.