Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Error: Finger Width cannot be less than 0.16um- TSMC 45nm (schematic)

rockykumar

Newbie level 5
Newbie level 5
Joined
Feb 17, 2022
Messages
10
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
187
During my W/L sizing in schematic design while using TSMC 45nm technology, I faced this issue of finger spacing. I did before also, but I never noticed this error. My MOSFET width size is 60. As I cannot set the MOSFET width more than 1.5um in this schematic design, so I prefer 1.5um as each width size and 40 as the number of fingers.
Is this error can be avoidable? Or there is something I have done wrong?

The error written in the picture is: "Finger spacing cannot be less than '0.16um' - setting finger spacing to 0.16um (P0.S.7)"
 

Attachments

  • Error.png
    Error.png
    28.6 KB · Views: 93

LaTeX Commands Quick-Menu:

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top