dave9000
Full Member level 2
I have ModelSim PE 6.6d crashing in the middle of a simulation with the following error dialog:
"modelsim is exiting with code 9"
After a few seconds Modelsim just quits!
Here is the transcript:
# ** Fatal: (vsim-4) ****** Memory allocation failure. *****
# Attempting to allocate 131072 bytes
# Please check your system for available memory and swap space.
# ** Fatal: (vsim-4) ****** Memory allocation failure. *****
# Attempting to allocate 131072 bytes
# Please check your system for available memory and swap space.
The problem always happens at the same point, after some 1M clock cycles.
What's going on?
"modelsim is exiting with code 9"
After a few seconds Modelsim just quits!
Here is the transcript:
# ** Fatal: (vsim-4) ****** Memory allocation failure. *****
# Attempting to allocate 131072 bytes
# Please check your system for available memory and swap space.
# ** Fatal: (vsim-4) ****** Memory allocation failure. *****
# Attempting to allocate 131072 bytes
# Please check your system for available memory and swap space.
The problem always happens at the same point, after some 1M clock cycles.
What's going on?