Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
mixer isolation is port to port isolation , so , when u apply LO , u need to measure the component of the LO which feed to the RF port and IF port , also when u inject thr RF singal check the attenuation of it in the IF port and so on
it can be done by using HB simulation in any RF simulator
mixer isolation is port to port isolation , so , when u apply LO , u need to measure the component of the LO which feed to the RF port and IF port , also when u inject thr RF singal check the attenuation of it in the IF port and so on
it can be done by using HB simulation in any RF simulator
khouly
can u detail it?how can HB simulation does?
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.