Mads Hedegaard Larsen
Newbie level 3
Hi Everyone.
I am relative new to HFSS, so I really could use some help to this one problem.
Im trying to measure the coupling between a Coplanar waveguide and a probe.
I have excited my CPW with to lumped ports, placed my probe 10 microns over the CPW and placed a Wave port on top of the probe (which is where i would like to measure the output of the coupling).
But this, weirdly enough, creates cut-off in my S parameters for the CPW. (Which where not there if system simulated without the waveport)
So I think it might be due to configuration of the waveport.
This might come as a silly question, but is there a way to only use the waveport as "receiver"?
Hope that somebody can help me.
// Mads
I am relative new to HFSS, so I really could use some help to this one problem.
Im trying to measure the coupling between a Coplanar waveguide and a probe.
I have excited my CPW with to lumped ports, placed my probe 10 microns over the CPW and placed a Wave port on top of the probe (which is where i would like to measure the output of the coupling).
But this, weirdly enough, creates cut-off in my S parameters for the CPW. (Which where not there if system simulated without the waveport)
So I think it might be due to configuration of the waveport.
This might come as a silly question, but is there a way to only use the waveport as "receiver"?
Hope that somebody can help me.
// Mads