Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

MAX3232 consuming 10mA+

Status
Not open for further replies.
S

sadat007

Full Member level 4
Full Member level 4
Joined
Dec 31, 1999
Messages
235
Helped
13
Reputation
26
Reaction score
7
Trophy points
1,298
Location
Pakistan
Activity points
1,773
Hi,
I used MAX3232 with non polar 100nF capacitor but the current it consuming is 10mA+ which is much much higher than its data sheet 1mA.
Any idea why?
thanks
sadat
 

Keep in mind that this IC can deliver up to 50-60mA (shortcircuit) to a load ..
Try to disconnect all outputs and measure it's current consumption again ..

Regards,
IanP
 

Hi
thanks
but this I already done... problem remains same.
thanks
sadat007
 

Yes no load connnected only 4 capacitors 100nf linked as per datasheet. Without these capacitors current lower than 1mA.
 

My Max202 takes about 4mA for 25% of loads the voltage also drops from -10V to about -8 volts, I think it is normal.
 

dsPIC24F said:
My Max202 takes about 4mA for 25% of loads the voltage also drops from -10V to about -8 volts, I think it is normal.
Click to expand...

Yes with load ok but without load..........
Can you check it without load if u can.
thanks
Sadat007
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top