Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

MAGMA : TIMER : QUERY, diffrent timing during optimization

Status
Not open for further replies.

hb_cancer

Member level 2
Joined
Jul 25, 2005
Messages
44
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,286
Activity points
1,596
MAGMA : TIMER : QUERY

Hi,
While using some optimization commands like "run optimize timing" or "run optimize size" etc.. I see that sometimes the command outputs a message on screen that the path is optimized and meeting the slack requirement{ +ve slack}. But if I do a "report timing summary" the timer show that the timing is not met.
So In general my query is why is the timer output during optmization different from the global timer.
Thanks!
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top