rahdirs
Advanced Member level 1
Hi,
I'm working with MIG v2.1.While trying to write to DDR3,there is some wierd data which is coming at ddr3_dq signal which is getting written to DDR3.
This is happening even before calibration signal becomes high & also after it goes high.
Junk data before calibration signal goes high
Junk data after calibration signal goes high
Obviously,i'm reading that junking data when i give read command
I'm working with MIG v2.1.While trying to write to DDR3,there is some wierd data which is coming at ddr3_dq signal which is getting written to DDR3.
This is happening even before calibration signal becomes high & also after it goes high.
Junk data before calibration signal goes high
Junk data after calibration signal goes high
Obviously,i'm reading that junking data when i give read command
Last edited: