pigkiller
Member level 4
:roll:
hi,all
When i simulate the structure based on the attachment,i can't get the result i need.
When i define the excitations,it's said in the manual of HF$$9 that the LUMP port is the proper one,however,When i use 30,20,10 um overlap in my model,the results are not gradual.
Then i use the wave port which i can do deembedding,i enlarge the length of the model,about 10*(length of the metal),but the result is even bad,how can i?
i define no boundary,i wonder if i'm right?
In which situation should i use PML boundary conditions?
thanks a lot! God save me!
hi,all
When i simulate the structure based on the attachment,i can't get the result i need.
When i define the excitations,it's said in the manual of HF$$9 that the LUMP port is the proper one,however,When i use 30,20,10 um overlap in my model,the results are not gradual.
Then i use the wave port which i can do deembedding,i enlarge the length of the model,about 10*(length of the metal),but the result is even bad,how can i?
i define no boundary,i wonder if i'm right?
In which situation should i use PML boundary conditions?
thanks a lot! God save me!