LOSTISLAND
Member level 3
ICD3 & PICKIT3 debuggers don't debug
Hi all ,
Even though ICD3 & PICKIT3 programmers work properly , ICD3 & PICKIT3 debuggers don't debug
Configuration bits :
__CONFIG _CP_OFF & _MCLRE_OFF & _WDT_OFF & _PWRTE_ON & _INTRC_OSC_NOCLKOUT
IDE :
MPLAB IDE 8.73
Toolsuit :
MICROCHIP MPASM Toolsuit
Microcontroller :
PIC16F639
This is the error while trying to debug when the debugger ICU3 is selected :
ICD3Err0040: The target device is not ready for debugging.
Please check your configuration bit settings and program
the device before proceeding.
Thanks in advanced
- - - Updated - - -
Here's the programmer connector :
Hi all ,
Even though ICD3 & PICKIT3 programmers work properly , ICD3 & PICKIT3 debuggers don't debug
Configuration bits :
__CONFIG _CP_OFF & _MCLRE_OFF & _WDT_OFF & _PWRTE_ON & _INTRC_OSC_NOCLKOUT
IDE :
MPLAB IDE 8.73
Toolsuit :
MICROCHIP MPASM Toolsuit
Microcontroller :
PIC16F639
This is the error while trying to debug when the debugger ICU3 is selected :
ICD3Err0040: The target device is not ready for debugging.
Please check your configuration bit settings and program
the device before proceeding.
Thanks in advanced
- - - Updated - - -
Here's the programmer connector :