rado
Member level 2
I am a beginner using PIC microcontrollers , what should you care about while using a pic microcontroller?
i had programmed it, done the whole circuit on a breadboard. the board was somewhat crowded. and the response was not good. so i decided to start the same part by part.
I am using an 8MHz crystal oscillator, gives a 5v supply.
how should i check the response of microcontroller?
how much voltage should i expect at the output ports?
should i use a resistor to connect the clear pin to 5v supply?
shall i connect the output directly to a 7447 ic chip {BCD to 7 segment decoder }?
I expects your advice, instructions etc;-)
i had programmed it, done the whole circuit on a breadboard. the board was somewhat crowded. and the response was not good. so i decided to start the same part by part.
I am using an 8MHz crystal oscillator, gives a 5v supply.
how should i check the response of microcontroller?
how much voltage should i expect at the output ports?
should i use a resistor to connect the clear pin to 5v supply?
shall i connect the output directly to a 7447 ic chip {BCD to 7 segment decoder }?
I expects your advice, instructions etc;-)