maksimtpl
Newbie level 4
Hello everybody,
I kind of new in the simulation tools (cadance). I wan to ask how I gonna set initial condition for my circuit with "extracted" (post simulation) juz like when in schematic. I need to setup some initial conditions in order to make the system converge. Can anybody tell me how to do that because is quite urgent for me?
Thanks you.
---------- Post added at 01:22 ---------- Previous post was at 01:11 ----------
btw my post-layout simulation in Calibre
I kind of new in the simulation tools (cadance). I wan to ask how I gonna set initial condition for my circuit with "extracted" (post simulation) juz like when in schematic. I need to setup some initial conditions in order to make the system converge. Can anybody tell me how to do that because is quite urgent for me?
Thanks you.
---------- Post added at 01:22 ---------- Previous post was at 01:11 ----------
btw my post-layout simulation in Calibre