Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

How to keep power rails different +5v and 3.3v in eagle

Status
Not open for further replies.

ep.hobbyiest

Full Member level 4
Full Member level 4
Joined
Jul 24, 2014
Messages
212
Helped
1
Reputation
2
Reaction score
1
Trophy points
18
Visit site
Activity points
1,487
i am using eagle v7.1. i drawing schematic i facing problem to keep the +5v and 3.3v different.
How to do this.
and also how can i keep different DGND and AGND.
 

Have you check the libraries Supply1 and supply2 in supply1 there are separate symbols for supply +5V and +3.3 volts and many others symbols related to supply.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top