how to interface Lumex LCM-S01602DTR/B

Thread starter muneebziaa
Start date Dec 1, 2012

Status: Not open for further replies.

Dec 1, 2012

muneebziaa

Newbie level 5

Hi all,

I am using ml403 FPGA board and Lumex LCM-S01602DTR/B is built on the board, i have found out how to initialize it but can't figure out how to use second line of the LCD. if some one here have interface this LCD with any controller or can give me any detail on this LCD. I couldn't find its datasheet any where expect of few datasheet which shows its pin configuration.

My basic problem is I couldn't find the command instruction list of this LCD. If some one can provide me this instruction list of this LCD i will be thank full to him.

Regards,
Muneeb

Status: Not open for further replies.

Similar threads

K
explanation of how to translate C code into verilog
- Started by keikaku
- Mar 5, 2024
- Replies: 10
PLD, SPLD, GAL, CPLD, FPGA Design
S
how to set global include in synplify, like vivado "set global include"
- Started by skyworld_cy
- Dec 21, 2023
- Replies: 5
PLD, SPLD, GAL, CPLD, FPGA Design
M
How to instantiate another vhd file inside testbench, where the testbench is used for opening files
- Started by metamisers
- Jan 6, 2024
- Replies: 6
PLD, SPLD, GAL, CPLD, FPGA Design
M
How to solve this issue of "No Hardware" in Quartus 13
- Started by MSAKARIM
- Sep 3, 2023
- Replies: 10
PLD, SPLD, GAL, CPLD, FPGA Design
A
Use interface signals as inout in systemverilog
- Started by antlhem
- Apr 1, 2023
- Replies: 0
PLD, SPLD, GAL, CPLD, FPGA Design

how to interface Lumex LCM-S01602DTR/B

muneebziaa

Newbie level 5

Similar threads

Privacy & Transparency

Privacy & Transparency