muneebziaa
Newbie level 5
- Joined
- Sep 13, 2012
- Messages
- 8
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Activity points
- 1,359
Hi all,
I am using ml403 FPGA board and Lumex LCM-S01602DTR/B is built on the board, i have found out how to initialize it but can't figure out how to use second line of the LCD. if some one here have interface this LCD with any controller or can give me any detail on this LCD. I couldn't find its datasheet any where expect of few datasheet which shows its pin configuration.
My basic problem is I couldn't find the command instruction list of this LCD. If some one can provide me this instruction list of this LCD i will be thank full to him.
Regards,
Muneeb
I am using ml403 FPGA board and Lumex LCM-S01602DTR/B is built on the board, i have found out how to initialize it but can't figure out how to use second line of the LCD. if some one here have interface this LCD with any controller or can give me any detail on this LCD. I couldn't find its datasheet any where expect of few datasheet which shows its pin configuration.
My basic problem is I couldn't find the command instruction list of this LCD. If some one can provide me this instruction list of this LCD i will be thank full to him.
Regards,
Muneeb