Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
You can start with 8051 or PIC microcontroller. You can write programs in assembly or C language. Codes in assembly language requires less memory for same code in C. But writing assembly language program for complex application is difficult to write, change and debug. You can write program in keil UVision µVision IDE - Overview. UVision allow you to simulate and debug your code before burning in microcontroller. You can burn code microcontroller by using flash magic software Flash Magic - Welcome. You also require a burner (hardware) that you can use available in your college.
burning mcu is by using a corrosponding software of each microcontrol'S . use ponyprog it has a suport a multi mcus .simulation can be done by using proteus or multisim. Ok just tell which mcu you are using
---------- Post added at 05:02 ---------- Previous post was at 04:57 ----------
burning mcu is by using a corrosponding software of each microcontrol'S . use ponyprog it has a suport a multi mcus .simulation can be done by using proteus or multisim. Ok just tell which mcu you are using
Dear Friend,
If you beginner start with MPLAB
winpic800 is good burner
use IDE Simulator, it is good for beginner
assembly language is good optimize language for programing
what else you need
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.