desertfox
Newbie level 4
lumped port calibration
HFSS newbie here
I am trying to simulate an Interconnect line test structure mouted on a Silicon substrate. Its basically 2 lines in Parallel and i need to define 2 ports on either side to get the S Parameters. Question is, If I use Lumped Gap source to define the Ports,
How do I Draw the Calibration and Impedance Lines? Can Someone describe how to do it or Does anyone have any Graphical Examples or links?
Thanks
Added after 52 minutes:
I have attached a Drawing of the Structure... it is Top view, and i have labled the Pads a,b,c and d for easy reference... where do the impedance and calibration lines go?
HFSS newbie here
I am trying to simulate an Interconnect line test structure mouted on a Silicon substrate. Its basically 2 lines in Parallel and i need to define 2 ports on either side to get the S Parameters. Question is, If I use Lumped Gap source to define the Ports,
How do I Draw the Calibration and Impedance Lines? Can Someone describe how to do it or Does anyone have any Graphical Examples or links?
Thanks
Added after 52 minutes:
I have attached a Drawing of the Structure... it is Top view, and i have labled the Pads a,b,c and d for easy reference... where do the impedance and calibration lines go?