Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

HFSS bent monopole design

Status
Not open for further replies.
I

Ibso

Newbie level 2
Joined
Sep 23, 2014
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
12
Greetings all,
as you will conclude from my question i am a complete newbie in HFSS.
i have this design problem, a pcb with a monopole wire sticking out and it is bent to be parallel to the surface in a ' Π ' shape. i have no clue how to go about doing that, so if anyone can help it would be greatly appreciated :)
 

Screenshot from 2014-09-28 22:43:55.png

i managed to draw the shape i wanted using draw=>line ... now the problem is defining the connection point between the PCB and the antenna as feeding point (excuse the lack of aproperiate HFSS lingo being a beginner and all :) ) .. any suggestions ?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top