Help me choose a microcontroller to interface temperature sensor

Hi,

if you want to make simple temperature sensor/controller, you can use IC LM35 and microcontroller 89c51.
For more information open given link....

**broken link removed**

Hello everyone. My next step is programming.... As I have already mentioned, I would like to determine the State of Charge(SoC) by reading the Voltage across the battery using the A/D module of PIC microcontroller. Any tips on programming? Like what is the approach to be followed(coz I am a newbie) and what are the steps, what should I do to start with?

Thanks

Please refer some of the following sites-

to start programming -

http://www.microchipc.com/sourcecode/#interface
http://www.best-microcontroller-projects.com/pic-projects.html
http://www.codeproject.com/Articles/29528/Programming-the-PIC-Microcontroller-in-C-using-PIC

Temeperature sensor project on PIC -

http://www.ermicro.com/blog/?p=844

may be helpful to you

Good Luck

Thank you very much BigDogGuru.... I have some doubt about PIC microcontroller. I want to know, is it possible to group the channels of ADC module in PIC micro controller, I mean, there are a total of 8 channels in ADC module, so can I group them, say 5 in one group to perform ADC and 3 in other group to perform some Sample and Hold circuit.... Is it possible to do it?


Thanks in advance.....

---------- Post added at 09:33 ---------- Previous post was at 09:31 ----------

Thank you very much BigDogGuru and Rick.... I have some doubt about PIC microcontroller. I want to know, is it possible to group the channels of ADC module in PIC micro controller, I mean, there are a total of 8 channels in ADC module, so can I group them, say 5 in one group to perform ADC and 3 in other group to perform some Sample and Hold circuit.... Is it possible to do it?


Thanks in advance.....