Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help in routing the top layer

Status
Not open for further replies.
M

msadek_eng

Advanced Member level 4
Full Member level 1
Joined
May 28, 2004
Messages
117
Helped
7
Reputation
14
Reaction score
2
Trophy points
1,298
Activity points
771
Please help me n this issue
my prefered pcb designer is protel and i want to make it route the top layer in vertical or horizontal lines and avoid using the pads of the component as vias because it heart when solder.
HOW
Thanks in advance
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top