Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help in Clock generator CY22150

Status
Not open for further replies.

sabiram164

Newbie level 4
Joined
May 10, 2008
Messages
6
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Activity points
1,332
Hi!
I trying to program a Cypress part CY22150 which is a clock generator. As indicated I am using this CyclocksRT (downloaded from Cypress website) software to specify the desired clock frequencies(upto 6 clock frequencies) and program this CY22150. I am using a evaluation board CY30700 used to check the capabilities of CY22150. I created the jedec file with the desired output clock frequencies and loaded it to the device CY22150. But when I used a oscilloscope to check the desired output frequencies, I did not find the programmed frequencies. I saw some pre-configured clock frequencies. I dont where I am going wrong. Could anyone please help me out. Thanks in advance.
 

Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Top