sabiram164
Newbie level 4
Hi!
I trying to program a Cypress part CY22150 which is a clock generator. As indicated I am using this CyclocksRT (downloaded from Cypress website) software to specify the desired clock frequencies(upto 6 clock frequencies) and program this CY22150. I am using a evaluation board CY30700 used to check the capabilities of CY22150. I created the jedec file with the desired output clock frequencies and loaded it to the device CY22150. But when I used a oscilloscope to check the desired output frequencies, I did not find the programmed frequencies. I saw some pre-configured clock frequencies. I dont where I am going wrong. Could anyone please help me out. Thanks in advance.
I trying to program a Cypress part CY22150 which is a clock generator. As indicated I am using this CyclocksRT (downloaded from Cypress website) software to specify the desired clock frequencies(upto 6 clock frequencies) and program this CY22150. I am using a evaluation board CY30700 used to check the capabilities of CY22150. I created the jedec file with the desired output clock frequencies and loaded it to the device CY22150. But when I used a oscilloscope to check the desired output frequencies, I did not find the programmed frequencies. I saw some pre-configured clock frequencies. I dont where I am going wrong. Could anyone please help me out. Thanks in advance.