Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Help: Component Pads not showing in PADS Layout 2005 SPAC2

Status
Not open for further replies.

kevinj

Advanced Member level 4
Full Member level 1
Joined
Jan 19, 2006
Messages
117
Helped
8
Reputation
16
Reaction score
4
Trophy points
1,298
Activity points
2,233
I have this weird problem where the pads for through-hole components and vias are not showing on the top layer. They do show on the bottom layer however. Surface mount pads are shown ok. I have a split/mixed plane on the top layer. I made sure that the "Pads" and "Vias" checkbox in the Display Colors are checked. Also I double checked the pad stacks and they are fine.

However when I create the gerber files, the pads are there.

Does anybody know how to get the pads to show again?

Thanks!
 

Try typing " L1 enter "or
L2 enter for 2 layer pcb
If a different layer is active, such as slik then pads may not show.
 

    kevinj

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top