Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Hand-made „intelligent” wipers

Status
Not open for further replies.

Vermes

Advanced Member level 4
Joined
Aug 2, 2011
Messages
1,163
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,316
Activity points
22,318


This system uses microcontroller Atmega8L, that realizes „intelligent” control over wipers in virtually every car. The system and its control using only one button is very simple, what is a great advantage when you drive a car.

How it works:
When you need to use wipers, press the button. Then the system activates wipers – one course, and it starts to countdown time (one second resolution). If while 45 seconds or another short time you do not press the button, the system „thinks” that only a single course was needed and it goes to standby. But when you press the button before 45 seconds, then the system activates wipers again – one course – and remembers the time interval from the previous to the current pressing the button. From that moment, wipers are activated for one course in intervals equal with that time. When weather conditions get worse and you begin to loose visibility, press the button again, which makes a single wipers activation and shortening the previously memorized time, what results in wipers running in a shorter intervals. You can thus lead to the continuous operation of the wipers. Short holding the button turns off the wipers, erasing the stored time and transition into a state of waiting for the next pressing. In this way you can completely turn off the wipers, or set a new, longer time, for which the wipers are activated for a single course.
The system was made to be installed under the hood of the car and connected to the wiper motor connector in a way so you can choose to use „intelligent” control or original wipers system.

Some pictures of the system, assembled and disassembled:



Connecting to the socket of the wiper motor in TICO:



Circuit diagram of the wipers control system in TICO:



Circuit diagram of the wipers control system in TICO with connected „intelligent” wipers system:



How it looks:



Multifunctional button: on, off and change of wipers operation frequency. Any button that shorts the contacts when pressed and opens the contacts when released.



And a simple scheme of the system.



Link to original thread (useful attachment) – Konkurs - "Inteligentne" wycieraczki.
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top