guidlines for data bus, clock and high speed signals routing

Status
Not open for further replies.
S

s3034585

Full Member level 4
Joined
May 24, 2004
Messages
226
Helped
1
Reputation
2
Reaction score
0
Trophy points
1,296
Activity points
2,087
hi guys

i am new to pcb routing. can anyone pls tell me some guidlines to follow while routing data bus, clock and high speed signals..... i know that data bus, differential signals, address bus have to be of same length from the point of timing... i am trying to equalize nets in altium designer. the pin out of the devices makes it bit difficult to route on the same layer. is it fine doing so...

can some one pls help me this... if some one has any info pls let me know...

thanks in advance
tama
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…