s3034585
Full Member level 4

hi guys
i am new to pcb routing. can anyone pls tell me some guidlines to follow while routing data bus, clock and high speed signals..... i know that data bus, differential signals, address bus have to be of same length from the point of timing... i am trying to equalize nets in altium designer. the pin out of the devices makes it bit difficult to route on the same layer. is it fine doing so...
can some one pls help me this... if some one has any info pls let me know...
thanks in advance
tama
i am new to pcb routing. can anyone pls tell me some guidlines to follow while routing data bus, clock and high speed signals..... i know that data bus, differential signals, address bus have to be of same length from the point of timing... i am trying to equalize nets in altium designer. the pin out of the devices makes it bit difficult to route on the same layer. is it fine doing so...
can some one pls help me this... if some one has any info pls let me know...
thanks in advance
tama