Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
Procedure for dump fsdb use ModelSim(winnt , verilog)
1.install Modelsim
2.install Debussy
3.
//add fsdb PLI in your testbench
initial begin
$fsdbDumpfile("pattern.fsdb";
$fsdbDumpvar(0,pattern);
end
4. copy debussy/share/pli/modelsim/novas.dll
copy debussy/share/pli/modelsim/novas_verilog.v
to your module directory
5. change modlsim.ini writeable(defaule is readonly)
mark Veriuser=....
then add veriuser=novas.dll
6.use modelsim to compile your design, don't forget include novas_verilog.v
7.simulate -> Run All -> finish
you will see pattern.fsdb in this folder
becsuae many people ask about this question,
so I re-write a more clear procedure.
enjoy it!
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.